Ctcss Scan - Alinco DR-138 Instruction Manual

UP / DOWN keys) to enter the setting and return to original status. The
T/SQ/DCS icon will remain on the display to show the current selective-
calling status. To exit, simply use the TS/DCS key and press it until the
relative status icon T/TQ/DCS disappears.
The CTCSS encoding and decoding frequencies may be set differently.
The encode setting frequency automatically relates to the decode
setting, but decode setting does not affect encode. The standard set of
50 different CTCSS tones are available. DCS encode/decode cannot be
separated. The list of selectable tones and codes is shown on Appendix
at the end of this booklet.

CTCSS SCAN

Repeatedly press key until LCD
displays icons ,then hold
to enter into CTCSS scanning. Once finding a
matching CTCSS tone, a voice will be heard
and resumes scanning after 15s.
DCS SCAN
Repeatedly press key until LCD
displays DCS icons ,then hold
1S to enter into DCS scanning. Once finding
a matching DCS code,a voice will be heard
and resumes scanning after 15s.
HIGH/MID/LOW Power switch
Press key until LCD display
then press key to switch between
CALL
high/Mid/low power. The LCD appears:
None: Transmit in high power
key for 1S
key for
iron,
: Transmit in middle power
: Transmit in low power
Compander (Decrease the background noise and ENHANCE
AUDIO CLARITY)
Compander function will decrease the
background noise and enhance audio clarity.
1.
Press key, then press
to turn on compander function, repeat
above operation again to turn off .
2. W h e n " " i c o n i s d i s p l a y e d ,
compander is active.
7
key
MONI
14