Display Iiiumination Color Setting; Scan Resume Time Setup; Lcd Dimmer; Tone-Burst Tones - Alinco DR-138 Instruction Manual

Display iiiumination color setting

This is to select the display illumination color.
1.
Press and hold / key for over 2 seconds to enter setting menu.
2.
Press / key to choose No.22 menu, LCD displays "COL--
ORG".
3. Turn Main Dial to select the desired color. Available colors are:
ORG-Orange, PUR-Purple, and BLU-Blue.
4.
Press key to confirm and exit.

Scan resume Time Setup

There are 3 kinds of scan resume conditions.
1.
Press and hold key for over 2
seconds to enter setting menu.
2.
Press / key to choose No.23
menu, LCD displays "SCAN--TO".
3. Turn Main Dial to select the desired
Scan Resume Time.
TO: Timed Scan, it resumes scanning
after receiving 5 seconds or when the
signal is gone, which ever faster.
CO: Busy Scan, it resumes scanning when the receiving signal is
gone.
SE: Stops scanning when a signal is received.
4.
Press key to confirm the selection and exit.

LCD dimmer

1.
Press and hold key for over 2 seconds to enter setting menu.
General Setting
2.
Press / key to choose No.24
menu, LCD displays "LAMP--25"
3. Turn Main Dial to select the desired
LCD brightness; 1 to turn off, 32 to the brightest.
4.
Press key to confirm and exit.

tone-burst tones

1.
Press and hold key for over 2 seconds to enter setting menu.
2.
Press / key to choose No.25
menu, LCD displays "TB--1750".
3.
Turn Main Dial to select the desired
tone frequency. Available tones are
1000,1450,1750 and 2100Hz.
4.
Press key to confirm the selection and exit.

Display Mode Setup

There are 3 different dispaly modes: Frequency+Memory mode, Channel
mode&Channel+Name Tag mode.
1.
Press and hold key for over 2 seconds to enter setting menu.
2.
Press / key to choose No.26 menu, LCD displays "DSP—
FR".
3.
Turn Main Dial to select the desired mode.
FR: Frequency+Memory mode.
CH:Channel mode.
NM:Channel+Name Tag mode, if channel
not named, it displays Frequency +
Memory mode.
4.
Press key to confirm and exit.
8
22