Transmitting - Alinco DR-138 Instruction Manual

Please hold the microphone approximately 2.5-5.0cm from your lips
then speak into the microphone in your normal speaking voice.
While transmitting, LED lights RED and TX-meter shows relative power level.
Release PTT to receive.
Transmitting Tone BURST TONE
Press and hold [PTT] key, then press Microphone [
transmit current selected tone-pulse signal.
Transmitting OPTIONAL SIGNALING
Press and hold [PTT] key, then press Microphone
key in front panel or press Mic's
CALL
selected DTMF/2Tone/5Tone optional signaling. Details will follow.
, and
] key to
key or press
key to transmit pre-stored and
Basic Operations
MEMORY CHANNEL PROGRAMMING
1. Under frequency mode (VFO), turn
selector knob to select the desired
frequency or input frequency by MIC's
numeric keys.
2.
Press key to enter CTCSS/DCS
TS/DCS
signaling setup, turn selector knob to
select the desired signaling.
3.
Press key, LCD appears
icon flashing means current channel is empty.
4.
Turn selector knob to select the desired channel number to store.
5.
Press key, , icon and channel number disappears and
beep sounds.
6. Press V/M key again to confirm that the memory channel is properly
stored.
MEMORY CHANNEL DELETING
1. Under Memory mode, turn selector knob to select channel to be
deleted.
2.
Press key and key together, current memory will be
deleted beep sounds. icon flashing means current memory is
deleted.
6
, icon and current channel number,
12