Optional Rewind - Gfp 563TH Operating Manual

20. Optional Rewind

One or two sets of Rewind devices can be added to the machine as required. One can be
fixed in the rear of the machine for rewinding finished material, and another on the front
of the stand to take up backing paper from the bottom roll of cold film when doing double-
side cold lamination.
Installing the Rewind device:
1. Remove 4 screws and inserts bolted inside each side frame
2. Bolt rewind motor assembly to control side frame and rewind bracket to opposite side
frame where the inserts were located
3. Slide cardboard core onto the rewind tube and insert the rewind tube onto the support
brackets
4. Plug rewind motor into power plug outlet at the rear of the side frame
Operating rewind motor:
1. Select "Combine" and the rewind shaft will match the speed of the laminator
2. Select "Single" and the rewind shaft runs independent of laminator
3. Adjust the speed or power of the rewind shaft with the Motor Torque knob
a. As the diameter of the rear rewind roll gets larger and the roll gets heavier, the
motor may need additional torque or power to maintain the same speed as the
laminator
4. Select "Forward" for the rewind motor to turn clockwise
5. Select "Reverse" for the rewind motor to turn counter-clockwise
6. Adjust the Shaft Clutch to keep the rewind shaft turning at the same speed as the
machine output
a. As the diameter of the rear rewind roll gets larger and the roll gets heavier, the
clutch may need to be tightened to keep the shaft clutch from slipping
Clutch
adjustment
19