Gfp 563TH Operating Manual page 4

• Contact an electrician should the attachment plug provided with the laminator not match the
receptacles at your location
Ensure that the voltages of the power supply you are using match the rated working
•
voltages before operations. Do not use incorrect power supply
Do not use damaged wires or sockets. If abnormal conditions occur, switch off the
•
power supply first.
Only a licensed electrician should install wiring and outlet for the laminator
•
• Do not defeat or remove electrical and mechanical safety equipment such as interlocks,
shields and guards
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
4