Loading Film - Gfp 563TH Operating Manual

11. Loading Film

1. Rotate the locking outer sleeve to the open position, aligned with the inner sleeve
2. Swing the supply shaft out to load position and slide the film roll onto the shaft
Note: If using Liner-in film, the web should come off the bottom of the roll, for Liner-
out film, the web should come off the top of the roll (see treading diagram in section #12)
3. Swing shaft back into position and rotate locking outer sleeve to the closed position
4. Align film roll with a number on the supply shaft, positioning the roll in the middle of
the supply shaft
5. Adjust the brake tension by turning the adjusting knob on top of the supply roll assembly
(see Brake tension adjustment section #15)
6. Repeat process with bottom supply shaft using Mounting adhesive or printed media roll
7. Position bottom supply roll using the same number position used on the top supply roll
to align top and bottom rolls
14