Ztp Settings - Printronix H-SERIES P7000 User Manual

Chapter 4

ZTP SETTINGS

Save Config.
This option allows you to save up to eight configurations to meet different print
job requirements. This eliminates the need to change the parameter settings
for each new job. The configurations are stored in memory and will not be lost
if you turn off the printer. If the Protect Configs. parameter is enabled, the new
configuration will not be saved unless the existing configuration has been
deleted first. The factory default configuration cannot be changed. See
"Saving Your New Configuration" on page 44 for details.
Power-Up Config.
You can specify which of the nine configurations (Factory or 1-8) will be the
power-up configuration.
ZTP SETTINGS
ZTP
1
SETTINGS
(from page 50)
ZTP
Function
Enable*
Disable
ZTP Function
This option enables or disables all unique ZTP functions. The default is
Enable.
NOTE: When the ZTP Function is enabled, the View/Eject key is disabled
ZTP TearDistance
This option sets the tear off distance from the current print position to the tear
bar. Adjustable values in increments of 1/144th of an inch range from 200 to
2880. The up and down arrows adjust the display value. When you press the
Enter key, the selected value is stored and a scale is printed to indicate the
current tear off position. The default value is 1060.
NOTE: When a new value is selected, the printer will lose the current print
56
ZTP ZTP
TearDistance Data Time
1074/144 Inch* .5 Sec*
1.0 - 5.0 Sec
and Slow Paper Slew is enabled.
position. You must reset the top of form to automatically save the new
value.
* = Factory Default
1
Available for Zero Tear Pedestal printers only.
ZTP ZTP
Wait Time Platen Open
2 Sec* Enable*
3 - 10 Sec Disable
1 Sec