Printek FormsMaster 8000 Operator's Manual page 98

A D V A N C E D S E T U P
Before sending the remote setup file to the printer, minimal setup is required
via the front panel setup menus. The I/O interface to be used for remote
setup must be configured appropriately to communicate with the host
system, and the "
" ".
Remote Setup
After this is done, the printer will reset, beep the bell to alert the operator,
and display the message "
may now be sent to the printer.
After the printer receives the remote setup file (without error), all specified
configuration changes will be made, the "
" ", and the printer will reset. When this reset is complete, the printer
Off
will be ready for normal interaction with the host system.
The available heading lines, and item setup lines, are documented below.
Note that all the legal values are shown for each item, but in use only one
value may be supplied in the setup file. An example file follows these
definitions.
92
F E A T U R E S
" item in the "
Test Mode
Waiting For Remote Setup
TEST MENU
". The remote setup file
" item will revert back to
Test Mode
" must be set to