Imager And Imagerplus Interface Items - Printek FormsMaster 8000 Operator's Manual

P R I N T E R C O N F I G U R A T I O N

Imager and ImagerPlus Interface Items

INTERFACE MENU
Imager
INTERFACE MENU
ImagerPlus
The printer will automatically display Imager or ImagerPlus as shown
above based upon which interface is installed. The descriptions in this
manual are brief. For more information, please refer to the appropriate
Imager or ImagerPlus manual.
Emulation
Possible Values:
This item sets the Imager or ImagerPlus emulation mode.
selects QMS Code V version 2,
version 2. Note that
Control Character
Possible Values:
This item sets the control character used to begin commands. The character
normally used for QMS is the caret (^) and the character nomally used for
IGP is the tilde (~) (if you change the emulation to
may need to change the control characcter to the tilde).
74
or
QMS CodeV v2*, PTX CodeV v2,
Printronix IGP
PTX CodeV v2
Printronix IGP
^ (5E Hex)*
SOH (01 Hex) through HT (09 Hex),
SO (0E Hex) through (FF Hex)
selects Printronix Code V
is only available in the ImagerPlus.
Emulation
QMS CodeV v2
QMS CodeV v2
ControlCharacter
^ (5E Hex)
, you
Printronix IGP