Loading Paper; Formsmaster 8000 Single Tractor Model - Printek FormsMaster 8000 Operator's Manual

LOADING PAPER

When shipped from the factory, the basic configuration for all ten forms is an
eleven inch form, six lines per inch, and ten characters per inch. If the forms
you are loading do not match these requirements, please refer to the "Printer
Configuration" chapter on page 39 and review the "Using Setup" and
"Forms Menu" sections.
Please refer to the appropriate section below for loading paper in the
FormsMaster 8000 or FormsMaster 8003.

FormsMaster 8000 Single Tractor Model

1. Make sure the printer is powered on and that the printer is off line
(ONLINE indicator flashing red).
2. Lift open the paper door on the front of the printer to expose the paper
feed tractors as shown below.
3. Open the doors on each tractor.
4. Feed the paper up through the bottom of the printer and position the
holes in the edge of the paper over the pins in the left tractor while
making sure that the paper will not extend above the top of the
tractors. Then close the tractor door.
FormsMaster 8000 Tractors
G E T T I N G S T A R T E D
13