Maintenance And Troubleshooting; Messages - Printek FormsMaster 8000 Operator's Manual

Maintenance and Troubleshooting

ERROR MESSAGES
This section provides a partial list of fatal errors. Fatal errors typically
cannot be recovered from without the loss of data. In each case,
shown on the top line of the display and one of the following messages is
shown on the bottom line. Suggested solutions for each of these messages
are listed to the right of each error message in the table which follows. If the
suggested solution does not solve the problem, please refer to "Obtaining
Service" on page 88.
Note that none of these messages "flash" on the display. Messages which
are flashed on the display are discussed in the "Common Error Conditions"
section on page 36.
Other errors which are not listed here or in "Daily Operation" should be
reported to the company where you purchased your printer, or to your
nearest Authorized Service Center. If you do not know the name or number
of your nearest Authorized Service Center, see "Obtaining Service" later in
this section.
Error Message
Head Stall
Bad Setup Module
Error Message
Possible
Solution
Check print head carriage area for
obstructions.
Check Setup Module to make sure it is
attached securely.
Replace Setup Module.
Possible
is
ERROR
87