Centrifugal External Adjustment System - GAS GAS Enduro 2T 250 2018 Owner's Manual

Owner's Manual

Centrifugal external adjustment system

1 2
pre-load value
adjustment
14.2 (250/300)
1 turn
1.5 turn 14.6 (250/300)
2 turns
15 (250/300)
(standard)
15.4 (250/300)
2.5 turns
3 turns 15.8 (250/300)
aDjuStMent Of tHe Pre-lOaDinG Of tHe CentrifuGal SPrinG
Dismantling and adjustment:
3 4
1.
2.
3.
assembly:
1.
2.
Site conditions or circuit type
(mm)
no grip (snow or mud)
difficult grip or technical circuit
correct grip or combination circuit optimum/standard
fast circuit
Very fast circuit
Remove the plug (1) with a 27mm wrench.
secure the adjustment screw (2) with a 2.5mm allen key and loosen the
locknut (3) with a 6mm angled spanner.
Tighten the screw (2) to the bottom and then tighten according to the
recommendation table.
secure the rotation of the adjustment screw (2) with a 2.5mm allen key
and tighten the locknut (3) with a 6mm angled spanner in order to lock the
adjustment system.
Ensure the correct positioning and condition of the copper gasket (4) replace
the plug (1) and tighten with a 27mm spanner and a maximum torque of 25nm.
power and Rpm limitation.
smooth power delivery
Live engine
Low torque at low Rpm and aggressive engine
-67-
engine performance.