Front Suspension Oil - GAS GAS Enduro 2T 250 2018 Owner's Manual

Owner's Manual
Maintenance
1

31.-frOnt SuSPenSiOn Oil

Adjusting the oil volume
To adjust the oil volume you must first remove the spring, follow the steps
described in "change of fork spring".
provide a graduated cylinder for liquids in which you must enter the indicated
volume of recommended oil (in each bottle).
slowly insert the oil from the graduated cylinder into the fork tube.
and to ensure the correct bleeding of the hydraulic push the rod gently and
alternatively throughout its entire length (up and down), several times, until its
stops.
Reassemble the fork cap assembly.
scrupulously respect the fill volume, since on this depends the level of oil in the
inside of the fork and its correct operation.
Recommended oil kyB 48: kyB 01m oil for closed cartridge suspension. oil
volume: 350 ml.
32.-BOltS, nutS anD faStenerS
Every day before using the bike, you should check that all nuts and bolts are
tightened. also check that the other fasteners are in place and in good condition.
33.-PetrOl tuBe
if you observe a pinch (narrowing) in the pipe (1) in any location (usually in the
petrol inlet to the carburettor and at the outlet of the petrol cock), or symptoms of
cracking on the surface, it is imperative to change the petrol tube.
DanGer
Riding with a damaged petrol tube or simply starting the engine can result in a fire
and consequently an accident (and corresponding injuries)
aLWays usE THE oRiginaL pETRoL TuBE, youR officiaL Gas Gas SerVIce
cEnTRE WiLL pRoVidE you WiTH onE.
-51-