Brakes Wear - GAS GAS Enduro 2T 250 2018 Owner's Manual

Owner's Manual
Maintenance
1
2
4

19.-BrakeS wear

if the thickness of any of the brake pads on the front or rear disc is less than 1mm,
a complete change of the affected pad set must be carried out.
DanGer
check that the thickness of the discs is at least 3 mm on the front and 3.5 mm on
the rear.
WarninG
for this change we recommend that you go to your official Gas Gas service centre
who, in addition, will check the possible wear of your brake discs.
changing the front brake pads
To change the front brake pads, follow these steps:
1. Loosen the pin (1) and remove it.
2. Remove the pads (2)
3. put a paper or cloth around the brake fluid tank to prevent it from falling.
open the cover by loosening the screws (3). note: for better access it is
recommended to loosen the screw (4) and turn the throttle assembly.
4. Remove the cover (5) ensuring that no brake fluid falls out of the tank.
5. Retract the two calliper pistons so as not to damage them.
6. install the new pads.
7. attach the pin.
8. Replace the cap of the tank.
9. operate the brake lever several times until you get the proper feel.
3
5
-46-