Radiator Tube And Connections - GAS GAS Enduro 2T 250 2018 Owner's Manual

Owner's Manual
Maintenance
1
1
3

17.-raDiatOr tuBe anD COnneCtiOnS

radiator tubes
check that the radiator tubes are not cut or damaged and that the connections
are not leaking.
radiator
check that the radiator fins (1) are not obstructed (insects or mud). clean the
obstructions with a low pressure water jet.
WarninG
using high pressure water can damage radiator fins and reduce their effectiveness.
do not obstruct or divert the air intake to the radiator by installing unauthorized
accessories. interference in the radiator can overheat and damage the engine.
18.-BrakeS aDjuStMent
front brake lever:
2
adjust the brake lever (1) until you feel comfortable. To adjust it, loosen the nut
(2). after adjusting it, tighten securely. check that the brake responds correctly.
rear brake pedal:
When the brake pedal (3) is in the rest position you should have a play of 5-7 mm.
check the brake for correct response and do not rub it.
DanGer
if the brake pedal or brake lever feels spongy when actuated, it may be because
there is air in the pump or circuit corresponding to each brake, or that a component
of the corresponding brake system is in poor condition.
since it is dangerous to ride in these conditions check the brakes immediately, for
this we recommend you go to your official Gas Gas service centre.
-45-