Cleaning - GAS GAS Enduro 2T 250 2018 Owner's Manual

Owner's Manual
Daily inspection before riding

Cleaning

are there any leaks? Visually check for possible leaks, assessing them based on
their location, amount and product leaked (pay attention to the danger of fire).
always go to your official Gas Gas dealer as quickly as possible.
DanGer
These controls are really very quick to carry out, it is a matter of habit, the user
knows the use to which the motorcycle has been subjected in its last use and knows
where it should this control be sharpened. Respect for this set of controls means
greater safety for the user and, certainly, better and more economical maintenance
of your motorcycle.
To clean your Gas Gas follow these steps:
1. cover the exhaust system to prevent water from entering.
2. cover the steering lock with a piece of duct tape.
3. Remove the mud and dirt with a low pressure water jet.
4. clean the areas that are particularly dirty with a special cleaner for
motorcycles.
5. Rinse with a jet of water at low pressure.
6. Let the motorcycle drain naturally.
7. Take a short ride on the motorcycle until the engine reaches its operating
temperature.
8. Lubricate the chain and all other elements that need it (see maintenance
section).
WarninG
never clean the vehicle using high pressure equipment. avoid direct contact
with multifunction gauge, coil, pipe plug, carburettor, switches, levers or any other
electrical element.
-32-