GAS GAS Enduro 2T 250 2018 Owner's Manual page 72

Owner's Manual
troubleshooting
The handlebar vibrates.
The motorcycle tends to lean to
one side.
The brakes do not work properly.
The lamps are melted.
The lights' system does not work.
Worn tire.
swingarm or its needle bearings are worn.
offset rim.
Wheels out of alignment.
steering axle with excessive tolerance.
Handlebar support loose, steering nut loose.
Bent chassis.
poorly adjusted steering.
Bent steering axle.
Bent front fork.
Wheels out of alignment.
Worn brake discs.
Loss of brake fluid.
impaired brake fluid.
piston pump broken.
Worn brake pads.
defective voltage regulator.
connectors in bad condition, regulator with
inadequate voltage output, check voltage stator
Replace the tire.
contact the official Gas Gas official service.
contact the official Gas Gas official service.
check the tension of the spokes of the rim.
Readjust if necessary.
check steering head adjustment.
check and adjust to the appropriate tightening
torques.
contact the official Gas Gas official service.
check steering play adjustment.
contact the official Gas Gas official service.
contact the official Gas Gas official service.
check the tension of the spokes of the rims.
change the discs.
contact the official Gas Gas official service.
contact the official Gas Gas official service.
contact the official Gas Gas official service.
check and change pads if necessary.
contact the official Gas Gas official service.
clean/change connectors, check regulator, check
voltage stator.
-72-