Homologation - GAS GAS Enduro 2T 250 2018 Owner's Manual

Owner's Manual

Homologation

note: This chapter is not valid for Xc models.
The vehicle you have just purchased is a vehicle approved under Eu directives and complies with all approval requirements.
The mandatory approval components for riding on public roads and for passing technical inspections at moT garages are, among others, those
detailed below.
The components of approval, among other requirements, are identified with a determined and registered marking
Each of the approved components must be part of the vehicle and in case of breakage, loss or malfunction the owner is advised to consult his
official Gas Gas dealer to correct the problem.
list of components
manufacturer's identification plate
catalysed exhaust
Homologated front and rear sprockets
carburettor dell'orto pHBg21
fuel overflow assembly
front and rear turn signals
Homologated licence plate holder + light + reflector
front reflectors
speedometer
Horn
Rear-view mirror
steering lock
secondary air valve
air filter restriction
Throttle opening limiter
Homologated fuel and starter cable
Blow-by tube assembly
Quantity/bike
1
1
1
1
1
4
1 / 1 / 1
2
1
1
2
1
1
1
1
1 / 1
1
-24-