Correction Factors 250 / 300Cc - GAS GAS Enduro 2T 250 2018 Owner's Manual

Owner's Manual
Carburator setting * for xC model
Correction factor 1.06 or higher
Needle position
Lower clip 1 position
opening screw free Tighten 1 turn
note: The values are indicative only

COrreCtiOn faCtOrS 250 / 300CC.

(for changes in height or temperature).
correction factor
Needle position / Air screw opening
1.06 ~ 1.02 1.02 ~ 0.98
same
Tighten ½ turn
1. find the correction factor to adjust carburizing.
example: 1000 m height and temperature of 35°c, correction 0.94.
2. using the correction factor, select the main jet.
example: factor 0.94, you must multiply the main jet by this number. main
jet = 175 x 0.94 = 165.
3. find your correction factor for the needle and air screw in the table and
change the position of the clip and the air screw opening.
example: Lift up the needle clip and turn the air screw one turn.
WarninG
To make corrections always take as a basis the competition carburetion. do not
make changes until you are sure they are needed. The specifications are based on
the use of recommended petrol and oil.
-61-
0.98 ~ 0.94
same same
same Loosen ½ turn
0.94 or less
Raise clip 1 position
Loosen 1 turn