Clean the OPC belt (right)
Procedure
IMPORTANT
Do not touch the OPC belt with your fingers. Wear cleaning gloves.
1. Rotate the metal OPC pulley until the spots are visible.
[84] Rotate the OPC pulley to locate the spots
2. Rotate the OPC pulley until the spots are in the indicated area.
NOTE
In this area, the OPC has a hard bottom surface which is required to enable proper
cleaning without damaging the OPC belt.
[85] Position the spots in the indicated area
3. Apply a small amount of Cleaner J on an offset pad.
4. Clean any spots with this offset pad.
When you cannot clean the spots with Cleaner J, use Cleaner P.
Océ VarioPrint 6000 line
Clean the OPC belt (right)
Chapter 3 - Maintenance tasks - Level 2
69