Adjusting The Brake Pedal - Toro Workman 07390 Operator's Manual

5. Install the rubber grip onto the parking-brake
lever (Figure 77).

Adjusting the Brake Pedal

Service Interval: Every 200 hours
1. Remove the hood.
2. Remove the cotter pin and clevis pin securing
the master-cylinder yoke to the brake-pedal
pivot (Figure 79).
1. Cotter pin
2. Brake-pedal pivot
3. Clevis pin
3. Lift up on the brake pedal
contacts the frame.
1. Brake pedal
4. Loosen the jam nuts securing the yoke to the
master-cylinder shaft
Figure 79
4. Master-cylinder yoke
5. Jam nut
(Figure 80) until it
Figure 80
2. Accelerator pedal
(Figure 79).
5. Adjust the yoke until its holes align with the hole
in the brake-pedal pivot
6. Secure the yoke to the pedal pivot with the clevis
pin and cotter pin
7. Tighten the jam nut securing the yoke to the
master-cylinder shaft
Note:
The brake-master cylinder must relieve
the pressure from the service brake when it is
properly adjusted.
8. Install the hood; refer to
(page 43).
g025532
g025531
59
(Figure 79).
(Figure 79).
(Figure 79).
Installing the Hood