Toro Workman 07390 Operator's Manual page 62

2. On both vehicles, disconnect the 2 quick coupler
hoses from the hoses secured to the coupler
bracket (Figure 84).
Figure 84
1. Quick coupler hose A
2. Quick coupler hose B
3. On the disabled vehicle, connect the 2 jumper
hoses to the hoses that were disconnected
(Figure 85).
Note:
Cap the unused fittings.
Figure 85
1. Disconnected hoses
4. On the other vehicle, connect the 2 hoses to the
coupler still in the coupler bracket (connect the
top hose to the top coupler and the bottom hose
to the bottom coupler) as shown
Note:
Cap the unused fittings.
g009822
g002429
2. Jumper hoses
inFigure 86.
1. Jumper hoses
5. Keep all bystanders away from the vehicles.
6. Start the second vehicle and move the lift lever
to the raise position, which raises the disabled
box.
7. Move the hydraulic-lift lever to the N
position and set the hydraulic-lift lock.
8. Install the bed support onto the extended-lift
cylinder; refer to
40).
Note:
With both the vehicles turned off, move
the lift lever back and forth to remove the system
pressure and ease the disconnection of the
quick couplers.
9. After completing the operation, remove the
jumper hoses and connect the hydraulic hoses
to both vehicles.
Important:
Check the hydraulic-fluid levels
in both vehicles before resuming operation.
62
Figure 86
EUTRAL
Using the Bed Support (page
g002430