Adjusting The Brake Pedal - Toro Workman 07390 Operator's Manual

2. Loosen the set screw securing the knob to the
parking-brake lever
1. Knob
2. Set screw
3. Rotate the knob
to 22 kg (45 to 50 lb) is required to actuate the
lever.
4. Tighten the set screw when finished
Note:
If you can no longer make a parking-brake
adjustment by adjusting the parking-brake
lever, loosen the handle to the middle of the
adjustment and adjust the cable at the rear, then
repeat step 3.
5. Install the rubber grip onto the parking-brake
lever (Figure 74).

Adjusting the Brake Pedal

Service Interval: Every 200 hours
1. Remove the hood.
2. Remove the cotter pin and clevis pin securing
the master cylinder yoke to the brake-pedal
pivot (Figure 76).
(Figure 75).
Figure 75
3. Parking-brake lever
(Figure 75) until a force of 20
(Figure
g033259
1. Cotter pin
2. Brake-pedal pivot
3. Clevis pin
3. Lift up on the brake pedal
contacts the frame.
75).
1. Brake pedal
4. Loosen the jam nuts securing the yoke to the
master cylinder shaft
5. Adjust the yoke until its holes align with the hole
in the brake-pedal pivot
6. Secure the yoke to the pedal pivot with the clevis
pin and cotter pin
7. Tighten the jam nut securing the yoke to the
master cylinder shaft
Note:
The brake master cylinder must relieve
the pressure from the service brake when it is
properly adjusted.
8. Install the hood.
57
Figure 76
4. Master cylinder yoke
5. Jam nut
(Figure 77) until it
Figure 77
2. Accelerator pedal
(Figure 76).
(Figure 76).
(Figure 76).
(Figure 76).
g025532
g025531