Electrical System Maintenance - Toro Workman 07390 Operator's Manual

Electrical System
Maintenance
Servicing the Fuses
The fuses for the electrical system are located under
the center of the dash panel
Figure 57
1. Fuses
Figure 58
1. Power takeoff—15 A
2. Engine start—10 A
3. Hazards—10 A
4. Engine ignition—10 A
(Figure 57 and Figure 58).
g025637
decal127-8626a
5. Differential lock—15 A
6. Speedometer—10 A
7. Headlights and rear
lights—15 A
8. Horn—30 A
Jump-Starting the Machine
WARNING
Jump-starting can be dangerous. To avoid
personal injury or damage to electrical
components in machine, observe the
following warnings:
• Never jump-start with a voltage source
greater than 15 VDC; this damages the
electrical system.
• Never attempt to jump-start a discharged
battery that is frozen. It could rupture or
explode during jump-starting.
• Observe all battery warnings while
jump-starting your machine.
• Be sure your machine is not touching the
jump-start machine.
• Connecting cables to the wrong post could
result in personal injury and/or damage to
the electrical system.
1. Squeeze the battery cover to release the tabs
from the battery base, and remove the battery
cover from the battery base
1. Battery cover
2. Connect a jumper cable between the positive
posts of the 2 batteries
Note:
The positive post may be identified by a
+ sign on top of the battery cover.
3. Connect 1 end of the other jumper cable to the
negative terminal of the battery in the other
machine.
49
(Figure 59).
Figure 59
(Figure 60).
g010326