Toro Workman 07390 Operator's Manual page 30

DANGER
In certain conditions during fueling, static
electricity can be released causing a spark
which can ignite the fuel vapors. A fire or
explosion from fuel can burn you and others
and can damage property.
• Always place fuel containers on the ground
away from your machine before filling.
• Do not fill fuel containers inside a machine
or on a truck or trailer bed because interior
carpets or plastic truck bed liners may
insulate the container and slow the loss of
any static charge.
• When practical, remove gas-powered
equipment from the truck or trailer and
refuel the equipment with its wheels on the
ground.
• If this is not possible, then refuel such
equipment on a truck or trailer from a
portable container rather than from a
fuel-dispenser nozzle.
• If you must use a fuel-dispenser nozzle,
keep the nozzle in contact with the rim of
the fuel tank or container opening at all
times until fueling is complete.
WARNING
Fuel is harmful or fatal if swallowed.
Long-term exposure to vapors can cause
serious injury and illness.
• Avoid prolonged breathing of vapors.
• Keep face away from nozzle and fuel tank
or conditioner bottle opening.
• Avoid contact with skin; wash off any spills
with soap and water.
1. Clean the area around the fuel-tank cap
28).
2. Remove the fuel-tank cap
(Figure
(Figure 28).
30
Figure 28
1. Fuel-tank cap
3. Fill the tank to about 2.54 cm (1 inch) below the
top of the tank, (bottom of the filler neck), then
install the cap.
Note:
Do not overfill the fuel tank with fuel.
4. Wipe up any fuel that may have spilled to
prevent a fire hazard.
g009814