Toro Workman 07390 Operator's Manual page 28

1. Coolant-reserve tank
3. If coolant is low, remove the reserve tank cap
and add a 50/50 mixture of water and permanent
ethylene-glycol antifreeze.
Note:
Do not overfill.
4. Install the reserve-tank cap.
Checking the Brake-Fluid Level
Service Interval: Before each use or daily—Check
the brake-fluid level. (Check the
level before the engine is first
started and daily thereafter.)
Every 1,000 hours/Every 2 years (whichever
comes first)—Change the brake fluid.
Brake-fluid type: DOT 3 brake fluid
Note:
The brake-fluid reservoir is shipped from the
factory filled with DOT 3 brake fluid.
The brake-fluid reservoir is located under the hood
and below the dash.
1. Park the machine on a level surface.
2. Remove the hood.
3. Check the fluid level in the brake-fluid reservoir
(Figure 26 and Figure
Note:
The fluid level should be up to the Full
line on the reservoir.
G019522
Figure 25
27).
1
1. Brake-fluid reservoir
g019522
1. Brake-fluid reservoir
4. If the fluid level is low, perform the following:
A. Clean the area around the cap for the
B. Remove the reservoir cap
C. Add the specified brake fluid to the Full line
D. Install the cap
5. Install the hood.
28
Figure 26
Figure 27
reservoir (Figure 27).
on the reservoir (Figure
Note:
Do not overfill the brake-fluid
reservoir.
(Figure
g009817
g002379
(Figure 27).
27).
27).