Toro Workman 07390 Operator's Manual page 26

Workman hdx-auto utility vehicle
Hide thumbs Also See for Workman 07390:
Table of Contents

Advertisement

3. Remove dipstick and check the level of the oil
(Figure
21).
4. If the oil level is low, remove the filler cap
21) and add enough oil to raise the level to the
Full mark on the dipstick.
Note:
When adding oil, remove dipstick to
allow proper venting. Slowly pour the oil into the
filler neck, and check the level often during this
process. Do not overfill the engine with oil.
1. Note the clearance between the fill device and the oil-fill
neck.
Important:
When adding engine oil or filling
oil, there must be clearance between the oil
fill device and the oil fill neck in the valve
cover as shown in
is necessary to permit venting when adding
oil.
5. Install the filler cap onto the filler neck
21).
6. Firmly install the dipstick into the dipstick tube
(Figure
21).
Checking the Hydraulic-Fluid
Level
Service Interval: Before each use or daily (Check
the level of hydraulic fluid before
the engine is first started and daily
thereafter.)
Hydraulic-Fluid Type: Mobil M15
Hydraulic-Fluid Capacity: (Non-TC model): 7.5 L
(2 US gallons)
Figure 22
Figure
22. This clearance
Hydraulic-Fluid Capacity: (Non-TC model with the
High-Flow-Hydraulic Kit (option) or TC Model): 15.1 L
(4 US gallons)
(Figure
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Make sure that all hydraulic fluid hoses
and lines are in good condition and all
hydraulic connections and fittings are tight
before applying pressure to the hydraulic
system.
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
• Seek immediate medical attention if fluid is
injected into your skin.
1. Clean the area around the filler neck and the
cap of the hydraulic reservoir
g002373
Figure
(Figure
1. Cap
26
24).
Figure 23
Hydraulic Fluid Level (Non-TC models)
2. Dipstick
(Figure 23
and
g024249
3. Filler neck

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workman 07390tcWorkman 07390h

Table of Contents