Changing The Hydraulic Fluid - Toro Workman 07390 Operator's Manual

Changing the Hydraulic
Fluid
Service Interval: Every 800 hours
Hydraulic Fluid Type: Mobil M15
Hydraulic Fluid Capacity: (Non-TC model): 7.5 L
(2 US gallons)
Hydraulic Fluid Capacity: (Non-TC model with the
High Flow Hydraulic Kit (option) or TC model): 15.1 L
(4 US gallons)
1. Position the machine on a level surface, shut
off the engine, engage the parking brake, and
remove the key from the key switch.
2. Raise the cargo box.
3. Remove the cap and dipstick from the filler neck
of the reservoir (Figure
Figure 83
1. Cap
2. Dipstick
3. Filler neck (hydraulic
reservoir)
4. Route the intake hose of the siphoning
equipment through the filler neck of the hydraulic
reservoir and to the bottom of the reservoir
(Figure 83).
5. Direct the discharge hose of the siphoning
equipment into a collection container
with a 11.4 L (3 US gallon) capacity—Non-TC
model or 18.9 L (5 US gallon) capacity—Non-TC
83).
g025578
4. Siphon equipment
5. Collection container
(Figure
model with the High Flow Hydraulic Kit (option)
or TC model.
6. Siphon the hydraulic fluid from the reservoir.
7. Remove the siphoning equipment from the
reservoir (Figure
8. Add 7.5 L (2 US gallons)—Non-TC model or
15.1 L (4 US gallons)—Non-TC model with the
High Flow Hydraulic Kit (option) or TC model of
the specified hydraulic fluid into the hydraulic
reservoir (Figure
Important:
specified. Other fluids could cause system
damage.
9. Install the dipstick and cap to the filler neck of
the hydraulic reservoir
10. Start the engine and operate the machine to fill
the hydraulic system.
11. Check the hydraulic-fluid level and replenish it,
if required.
Raising the Box in an
Emergency
You can raise the box in an emergency without
starting the engine by cranking starter or by jumping
the hydraulic system.
Raising the Box Using the Starter
Note:
If the engine does not start, you must remove
the load and box (attachment) in order to service the
engine.
1. Ensure that the transmission lever is in the P
(P ) position.
ARK
2. Crank the starter while holding the lift lever in
the R
AISE
Note:
Run the starter for 15 seconds then wait
60 seconds before engaging the starter again.
Raising the Box by Jumping the
Hydraulic System
Note:
This procedure requires 2 hydraulic hoses,
each with a male and a female quick coupler, that fits
the couplers on the machine.
1. Back another vehicle up to the rear of the
disabled machine.
Important:
83) M15. To avoid system contamination, make
sure that the vehicle you use to jump the
hydraulic system uses an equivalent fluid.
61
83).
83).
Use only the hydraulic fluids
(Figure 83).
position.
The hydraulic system uses Mobil