Toro Workman 07390 Operator's Manual page 54

5. Remove the drain plug from the drain port by
rotating the plug counterclockwise and removing
it from the transmission
Note:
Allow the transmission fluid to drain
completely.
6. Install the drain plug
7. Add 700 ml (23.7 oz) of Dexron VI transmission
fluid into the transmission through the fill port
(Figure 66).
Note:
Use a funnel with a flexible hose when
filling the transmission.
Note:
When the transmission fluid level is
correct, the fluid should be level with the bottom
of the threads in the fill port.
8. Install the fill plug
Servicing the Reservoir of the
Speed-Control Cylinder
Service Interval: Every 200 hours
Reservoir Fluid Type: DOT 3 brake fluid
1. Remove the knobs from the hydraulic-lift lever
and the speed-range lever
1. Knob (speed-range lever)
2. Rod (speed-range lever)
3. Knob (hydraulic-lift lever)
2. Remove the 6 hex-washer screws (#10 x 3/4
inch) that secure the control-cover plate to the
seat base, and remove the cover plate
68).
3. Move the speed-range lever to the transport
position; refer to
Control (page 33).
4. Check the fluid level in the reservoir for the
speed control cylinder
Note:
The normal fluid level is between the Min
and Max marks on the side of the reservoir.
(Figure 67).
(Figure 67).
(Figure 66).
(Figure 68).
Figure 68
4. Rod (hydraulic-lift lever)
5. Control-cover plate
6. Hex-washer screws (#10
x 3/4 inch)
Using the Speed-Range
(Figure 69).
1. Cap
2. Max mark (reservoir)
5. If the fluid level is low, perform the following:
A. Wipe clean the area around the cap for the
B. Remove the cap from the reservoir
C.
D. Install the cap hand tight
6. Align the holes in the control-cover plate to the
holes in the seat base
7. Secure the plate to the base with the 6
hex-washer screws
removed in step 2.
8. Thread the knobs onto the rods for the
hydraulic-lift lever and the speed-range lever
g025529
(Figure
Adjusting the Speed Control
Important:
the machine is 4.0 kph (2.5 mph) at full engine
speed. Controlling the machine speed slower that
4.0 kph (2.5 mph) results in excessive belt and
clutch wear.
(Figure
1. Drive the machine in speed range A (low range),
B (mid-low range), C (mid-high range), or D
(high range) in order to determine which speed
range includes the maximum-ground speed that
you want to set; refer to .
Note:
speed that the machine is traveling.
2. Remove the knobs from the hydraulic-lift lever
and the speed-range lever
54
Figure 69
3. Min mark (reservoir)
4. DOT 3 brake fluid
reservoir (Figure 69).
69).
Add the specified fluid to raise the level
midway between the Min and Max marks on
the side of the reservoir
(Figure
(Figure
68).
The minimum controlled speed for
Use the speedometer to determine the
g025530
(Figure
(Figure 69).
(Figure 69).
68).
68) that you
(Figure 68).