Adjusting the Brake Pedal
Service Interval: Every 200 hours
Note: Remove the font hoot to ease the adjustment
procedure.
1. Remove the cotter pin and clevis pin securing the
master cylinder yoke to the brake pedal pivot (Figure
62).
Figure 62
1. Master cylinder yoke
2. Lift up on the brake pedal (Figure 63) until it contacts
the frame.
3. Loosen the jam nuts securing the yoke to the master
cylinder shaft (Figure 63).
4. Adjust the yoke until its holes align with the hole in the
brake pedal pivot. Secure the yoke to the pedal pivot
with the clevis pin and cotter pin.
5. Tighten the jam nuts securing the yoke to the master
cylinder shaft.
Note: The brake master cylinder must relieve pressure
when properly adjusted.
2. Brake pedal pivot
1. Clutch pedal
2. Brake pedal
46
Figure 63
3. Accelerator pedal