Brake Maintenance; Adjusting The Parking Brake; Adjusting The Brake Pedal - Toro Workman HD 07369 Operator's Manual

Brake Maintenance

Adjusting the Parking Brake

Service Interval: After the first 10 hours
Every 200 hours
1. Remove the rubber grip from the parking-brake lever
(Figure 55).
Figure 55
1. Grip
2. Loosen the set screw securing the knob to the
parking-brake lever
Figure 56
1. Knob
2. Set screw
3. Rotate the knob until a force of 20 to 22 kg (45 to 50
lb) is required to actuate the lever.
4. Tighten the set screw when finished.
Note: If no adjustment is left at the handle, loosen the
handle to the middle of the adjustment and adjust the
cable at the rear, then repeat step 3.
5. Install the rubber grip onto the parking-brake lever.
2. Parking-brake lever
(Figure 56).
3. Parking-brake lever

Adjusting the Brake Pedal

Service Interval: Every 200 hours
Note: Remove the font hood to make the adjustment
procedure easier.
1. Remove the cotter pin and clevis pin securing the
master-cylinder yoke to the brake-pedal pivot
57).
1. Master-cylinder yoke
2. Lift up on the brake pedal
the frame.
1. Brake pedal
3. Loosen the jam nuts securing the yoke to the
master-cylinder shaft
4. Adjust the yoke until its holes align with the hole in
the brake-pedal pivot.
5. Secure the yoke to the pedal pivot with the clevis pin
and cotter pin.
6. Tighten the jam nuts securing the yoke to the
master-cylinder shaft.
Note: The brake master cylinder must relieve pressure
when properly adjusted.
46
Figure 57
2. Brake-pedal pivot
(Figure 58) until it contacts
Figure 58
2. Clutch pedal
(Figure 57).
(Figure