Storage - Toro Workman 07390 Operator's Manual

Storage

1. Position the machine on a level surface, engage
the parking brake, shut off the engine, and
remove the key from the key switch.
2. Clean dirt and grime from the entire machine,
including the outside of the engine cylinder head
fins and blower housing.
Important:
You can wash the machine
with mild detergent and water. Do not
use high-pressure water to wash the
machine. Pressure washing the machine
may damage the electrical system or wash
away necessary grease at friction points.
Avoid excessive use of water, especially near
the control panel, lights, engine, and battery.
3. Inspect the brakes; refer to
Pedal (page 59).
4. Service the air cleaner; refer to
Filter (page 45).
5. Grease the machine; refer to
Bearings and the Bushings (page
6. Change the engine oil and filter; refer to
Changing the Engine Oil and Filter (page
7. Check the tire pressure; refer to
Tire Pressure (page
8. For storage over 30 days, prepare the fuel
system as follows:
A. Add a petroleum based
stabilizer/conditioner to the fuel in the
tank.
Follow mixing instructions from the stabilizer
manufacturer. Do not use an alcohol-based
stabilizer (ethanol or methanol).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline
and the stabilizer/conditioner is used at all
times.
B. Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C. Shut off the engine, allow it to cool, and
drain the fuel tank.
D. Start the engine and run it until it stops.
E. Start and run the engine again until it does
not start again.
F. Dispose of drained fuel properly. Recycle
as per local codes.
Important:
stabilizer/conditioned gasoline for
over 90 days.
Adjusting the Brake
Servicing the Air
Greasing the
44).
Checking the
31).
Do not store
9. Remove the spark plugs and check their
condition; refer to
(page
10. With the spark plugs removed from the engine,
pour 2 tablespoons of engine oil into the
spark-plug hole.
11. Use the starter to crank the engine and distribute
the oil inside the cylinder.
12. Install the spark plugs and tighten each one to
the recommended torque; refer to
Spark Plug (page
Note:
spark plugs.
13. Check the anti freeze protection and add a 50/50
solution of water and anti freeze as needed for
expected minimum temperature in your area.
14. Remove the battery from the chassis, and
charge it fully; refer to
(page
Note:
battery posts during storage.
Important:
charged to prevent it from freezing and being
46).
damaged at temperatures below 0°C (32°F).
A fully charged battery maintains its charge
for about 50 days at temperatures lower
than 4°C (40°F). If the temperatures will be
above 4°C (40°F), check the water level in the
battery and charge it every 30 days.
15. Check and tighten all the bolts, nuts, and screws.
Repair or replace any part that is damaged.
16. Paint all the scratched or bare metal surfaces.
Note:
Service Distributor.
17. Store the machine in a clean, dry garage or
storage area.
18. Remove the key from the key switch and put it in
a safe place that is out of the reach of children.
19. Cover the machine to protect it and keep it clean.
63
Replacing the Spark Plug
47).
47).
Do not install the spark-plug wires on the
Servicing the Battery
51).
Do not connect the battery cables to the
The battery must be fully
Paint is available from your Authorized
Replacing the