Table of Contents
Advertisement
Adjusting the Brake Pedal
Service Interval: Every 200 hours
Note: Remove the font hoot to ease the adjustment
procedure.
1. Remove the cotter pin and clevis pin securing the
master cylinder yoke to the brake-pedal pivot
64).
Figure 64
1. Master cylinder yoke
2. Lift up on the brake pedal
the frame.
3. Loosen the jam nuts securing the yoke to the master
cylinder shaft
(Figure
4. Adjust the yoke until its holes align with the hole in
the brake-pedal pivot.
5. Secure the yoke to the pedal pivot with the clevis pin
and cotter pin.
6. Tighten the jam nuts securing the yoke to the master
cylinder shaft.
Note: The brake master cylinder must relieve pressure
when properly adjusted.
(Figure
2. Brake-pedal pivot
(Figure
65) until it contacts
65).
1. Brake pedal
49
Figure 65
2. Accelerator pedal
Advertisement
Table of Contents
