Table of Contents
Advertisement
INSTALLER GUIDE
bottom front sides of the convection
box. See figure 21.
7. Place the convection box fully back
into the fireplace opening so that it is
sealed against the fireplace front
surround.
8. Fit a cable retainer over the bottom
end of each cable.
9. Pull each cable taut. Push the cable
retainers hard up against the "V"
brackets. Tighten the screws in the
Figure 22. Lower Cable Retention
retainers so that they clamp the
cables in position. Apply tension to
the cables by turning the hexagonal
adjusters by hand. See figure 22.
10. Drill a hole into the fireplace
floor through each of the two holes
in the base of the convection box
using a no.12 masonry drill. See
figure 23.
Figure 23. Floor Fixing
11. Insert a fibre plug into each hole.
Use the rawlplugs supplied with this
appliance - Never use plastic plugs
instead of the fibre plugs supplied. Fit
a woodscrew in each plug and tighten.
12. Inspect the installation of the
convection box against the fireplace
surround. If the convection box is
aligned squarely and the sealing is
satisfactory, fully tighten the cable
retainers.
Figure 24. Floor Sealing
13. If the convection box is not
correctly aligned, release the tension on the cables by slackening the screws and turning
the hexagonal adjusters fully anticlockwise. The convection box should then
automatically realign itself. Pull each cable taut again and push the cable retainers back
against the "V" brackets. Again, tighten the screws in the retainers and apply tension to
the cables by turning the hexagonal adjusters clockwise as far as possible.
14. Push the free length of the cables inside the convection box so that they are
available to allow easy removal and refitting of the appliance during subsequent service
calls.
Page 21
Advertisement
Table of Contents
