Table of Contents
Advertisement
5. Replace in the reverse order. When refitting
the leads to the interrupter block, make sure that
they are secured firmly to give a good electrical
contact.
17.4 To Remove the Fire Front Surround
1. Remove the bottom front cover and the fire
front casting.
2. Detach the control-linking bar from the
control pivot bracket by removing the knurled
screw, which joins the control linking bar to the
control pivot unit. See figure 42.
3. Remove the two screws securing the bottom
of the front surround to the sides of the convection box. See
figure 43.
4. Make sure that the control linking bar has been detached
(See point 2 ). Carefully lift the surround unit upward to clear
the upper retaining brackets on the convection box - See figure
44. Pull the surround clear and place carefully aside.
5. Refit in the reverse order. Make sure that the surround is
properly located over the upper retaining brackets. See section
11 of this manual for detailed fitting instructions.
17.5 To Replace the Control Slide Button
1. Remove the front surround - See section 17.4
2. Detach the slide button by removing two
screws – See figure 44.
4. Replace in the reverse order.
17.6 To Remove the Burner Unit
1. Remove the front surround - See section
17.4.
2. Remove the loose ceramic fuel effect
pieces, the front ceramic fuel effect and the
base ceramic fuel effect.
3. Support the inlet 'T' connector to avoid
straining the pipework and disconnect the
appliance from the 'T' connector.
4. Detach the burner unit from the
convection box by removing two screws
INSTALLER GUIDE
Page 32
Figure 42. Control linkage
disconnection
Figure 44. Front Surround Bottom
location (Shown with Ultimate slide
button)
Figure 43. Outer
surround removal
Advertisement
Table of Contents
