Table of Contents
Advertisement
INSTALLER GUIDE
investigate the pilot unit.
14.1.2 Operating the burner.
1. Gradually slide the button up to increase the burner setting. The burner should be at
its maximum setting at the high heat position shown in figure 36. You should feel a
check to the button movement at this position.
2. Slide the control button up past the high heat position to the off ("O") position at the
top of the slide slot. Both pilot and main burner should go out.
While cooling the coals may make some crackling noises. This is quite normal.
3. Check that the control linkage bar does not interfere with the appliance cable
retention nuts or wires.
15. SPILLAGE & FLAME SUPERVISION CHECKS
15.1 Check for Spillage
A spillage check must be made before leaving the installed appliance with the
customer. Make this with all the ceramic fuel effect pieces in position.
1. Close all doors and windows in the room containing the appliance.
2. Light the appliance and lift the slider knob to "HIGH".
3. Leave the appliance on for five minutes.
4. Place the smoke match tube into the convection box at the right hand side and
immediately below the black top cross member. Angle it at approximately 45° to the
horizontal.
Insert the tube so that the neck of its flared end touches the inside surface of the edge of
the cross member - See figure 37.
Keeping the neck of flared end in contact with the edge of the cross member, slide the
tube to the left until you feel it enter the
notch in the edge of the cross member.
Make sure that the tube is pointed
upwards at 45º to the horizontal. The
installation is satisfactory if the smoke is
drawn into the appliance. If the smoke is
not drawn into the appliance leave the
appliance alight at the maximum setting
for a further ten minutes and then repeat
the test. If the smoke is still not drawn
Figure 37. Spillage check
into the appliance inspect the sealing to
Page 27
Advertisement
Table of Contents
