Table of Contents
Advertisement
INSTALLER GUIDE
4. Place a type "B" coal between the
front and rear base coals as shown in
figure 31. The letter "B" should be
upright.
5. Place a type "A" coal between the
front and rear base coals with the
letter "A" upright. The top of the coal
Figure 31.
should rest against the centre coal
of the rear base coal as shown in
figure 32.
6. Place the remaining type "B"
coal at the right side of the firebox
between the front and rear base
coals. The letter "B" should be
Figure 32.
upright. The coal should touch the
right side of the firebox. See figure
33.
7. Place the remaining type "A" coal
between the front and rear base coals.
The letter "A" should be upside down
with its rear face between the right
Figure 33.
and centre coals of the rear base
coal. Angle the coal so that the gap
between it and the type "B" coal to
its right is appreciably larger than
the gap between it and the type "A"
coal to its left but do not have it
touching the type "A" coal. This
will give the best flame effect. See
Figure 34.
figure 34
.
Page 25
Advertisement
Table of Contents
