Optional Printer Port (3.3.2) - Honeywell CM4 Technical Handbook

CM4 Four-Point Continuous Monitor
3 – SET-UP MODE
3 – OUTPUT OPTIONS
1 – COM PORT
The display reads:
COM PROT VER 1
Other choices include:
COM PROT VER 2
COM PROT LONWORKS
COM PORT DISABLED
Refer to the CM4 Serial Communications Protocol Manual (P/N
1998M0020) for more information.
3. After making a selection, press ENTER. The display reads:
COM PORT = 9600 BAUD
4. Press CURSOR ARROW RIGHT to advance the display from
1200, 2400, 4800, 9600, to 19200 baud.
5. Press ENTER when the display shows the desired baud rate.
The display reads:
BAUD RATE UPDATED
The display reads:
INST ADDRESS 001
6. Press ENTER after selecting the desired address. A unique
address must be assigned to each CM4 sharing an RS 485
bus.
The display then returns to the output options function.
Press RESET to return to the Set-Up Menu.
CM4 Technical Manual
and

7.4.2 Optional Printer Port (3.3.2)

Purpose
Use the printer port function to enable the optional communication
port and specify the baud rate for communication with the Network
as either:
• 1200 baud
• 2400 baud
• 4800 baud
• 9600 baud
• 19200 baud
Instructions
1. Press PROGRAM to exit Monitor Mode.
2. From the 3–SET-UP MENU, choose the subfunction 3–OUTPUT
OPTIONS, then 2–PRINTER PORT.
3 – OUTPUT OPTIONS
The display reads:
PRINTER PORT = ENABLE
3. Press CURSOR ARROW RIGHT to toggle between enabling
and disabling the printer port.
4. Press ENTER. The display reads:
PRINTER 9600 BAUD
5. Press CURSOR ARROW RIGHT to advance the display from
1200, to 2400, to 4800, to 9600, to 19,200 baud.
6. Press ENTER when the display shows the desired baud rate.
7-7
3 – SET-UP MODE
2 – PRINTER PORT