Section 3: Programming; Usb Port C; Password Requirements; User Login - Honeywell NOTIFIER NCD Instruction Manual

Network control display

Hide thumbs Also See for NOTIFIER NCD:

Product installation document (18 pages)

Table Of Contents

Table of Contents

This section describes the programing options for the NCD

3.1 USB Port C

There is an available USB port located on the front

panel of the NCD, see Figure 3.1. This USB port can be

used to conveniently connect to the VeriFire Tools PC.

3.2 Password Requirements

When power is first applied, the NCD will prompt the user to change the password. A trouble message stating

will be displayed. The master password can only be set through the NCD display.

The password guidelines are as follows: Passwords must be 8 to 16 characters, which can be a combination of alpha-numeric upper and

lower case characters and numbers. The password does not have a minimum of character types and is case sensitive

3.3 User Login

The

touch point is always present and located in the upper left hand corner of the screen. This option allows the user to cre-

USER LOGIN

ate and manage up to 50 unique password protected user accounts on the NCD. This login will allow access for various programing

options and programming levels on the NCD.

3.3.1 Adding and Removing a User

A user name cannot exceed 16 alpha numeric characters.

Adding a User

• At the main menu tap on the

touch point

then

USERS

• In the users menu tap on

. The screen will prompt

USER

you to create a user name and

a unique password for that

user name.

• The virtual keyboard will

appear

• Once a user name and

password has been entered

tap on

ADD USER

information

Removing a User

• At the main menu tap on the

touch point

then

USERS

• In the users menu tap on the

REMOVE USER

• The virtual keyboard will

appear enter the user name to

be removed then tap on