Table of Contents
Advertisement
CM4 Four-Point Continuous Monitor
The display shows the baud rate selected:
BAUD RATE UPDATED
The display reads:
HW HANDSHAKE DISABLE
Use the cursor keys to toggle between enable and disable. Press
ENTER.
7. Enable the handshake. The handshake, when enabled,
indicates a printer time-out fault on the maintenance relay.
The display reads:
HW HANDSHAKE ENABLE
This option enables RTS/CTS flow control on the printer output. The
CM4 is not capable of Xon/Xoff flow control.
Press CURSOR ARROW LEFT or RIGHT to toggle between enable
and disable. When the display shows ENABLE, press ENTER. The
display will momentarily show:
HW HANDSHAKE ENABLED
NOTE:
HW Handshake is not used for RS-422 operation. No printer
time-out is issued. If you are using RS-422 option (P/N 874023-F
or 874023-R) choose DISABLE and then press ENTER.
The display then returns to the output options function. Press RESET
to return to the instrument Set-up Menu. See
information.
For multiple instrument installations, repeat
CM4 monitor.
CM4 Technical Manual
7.4.3 Printer Format (3.3.3)
Purpose
Use the printer format function to define the format of the printout.
Instructions
The cursor is flashing over the current set-up.
Appendix D
for additional
Section 7.4.2
for each
7-8
1. Press PROGRAM to exit Monitor Mode.
2. From the 3–SET-UP MENU, choose the subfunction 3–OUTPUT
OPTIONS, then 3–PRINTER FORMAT.
3 – SET-UP MODE
3 – OUTPUT OPTIONS
3 – PRINTER FORMAT
The display reads:
SELECT REPORT
1=CONT 2=SUM 3=COMP
3. Select the type of report desired. Report contents are listed in
Table
7-1, use the numeric keys to select the type of report:
•
1, for Continuous Mode (CONT), which sends all information
to the printer, including point concentrations for every sample
period, alarm and fault data, and the 8-hour TWA.
or
•
2, for Summary Mode (SUM), which prints the alarm and
fault data and the 8-hour TWA.
or
•
3, for Compressed Mode (COMP), which prints all point
concentrations that exceed the lowest detectable limit, alarm
and fault data, and TWA information. This is the default
setting.
Table 7-1
shows a summary matrix.
Hide quick links:
Advertisement
Table of Contents
