Honeywell CM4 Technical Handbook page 151

CM4 Four-Point Continuous Monitor
Press CURSOR ARROW LEFT/RIGHT to toggle between ENABLE
and DISABLE. When the display shows ENABLE, press ENTER. The
display will momentarily show:
HW HANDSHAKE ENABLED
NOTE:
HW Handshake is not used for RS-422 operation. No printer
time out is issued. If you are using RS-422 option P/N 874023-R
choose DISABLE and then press ENTER.
The display then returns to the output options function. Press reset to
return to the instrument Set-up Menu.
For multiple instrument installations, repeat Steps 1-7 for each CM4
monitor.
Select the Printer Format:
The CM4 monitor can send reports to a printer in three different
formats:
• Continuous Mode (CONT ) In this mode, all information is
printed, including point concentrations for every sample period,
alarm and fault data, and the 8-hour TWA.
• Summary Mode (SUM) This mode provides a printout of alarm
and fault data and the TWA.
• Compressed Mode (COMP) This mode provides a printout
of all point concentrations that exceed the lowest detectable
limit, alarm and fault data, and TWA information. This is the
default and the recommended mode.
One printer will sustain the output information of five CM4 monitors.
However, if you are sending information from five CM4 monitors to
a single printer, you should consider the type of report you wish to
print. Five CM4 monitors operating in a continuous mode will send
enough data to the printer to fill approximately 1200 sheets of paper
CM4 Technical Manual
in a 24-hour period. Therefore, if you are operating continuously, we
recommend you select either the Summary or Compressed Mode.
Follow these instructions to define the format of the printout:
1. Press PROGRAM to exit the Monitor Mode.
2. From the 3 - SET-UP MENU, choose the subfunction 3 -
OUTPUT OPTIONS, then select 3 - PRINTER FORMAT.
3 - OUTPUT OPTIONS
3 - PRINTER FORMAT
The display reads:
1=CONT 2=SUM 3=COMP
The cursor flashes over the current set-up selection.
3. Choose the type of report desired. Use the numeric keys to
select 1, 2, or 3. The display will show:
PRINT FORMAT UPDATED
4. The CM4 monitor's software will automatically return to the
Output Options menu.
Printer:
Make sure paper is properly loaded into the printer. Switch the
printer On; perform any set-up procedures as required by the
printer manufacturer. Consult the printer
detailed instructions.
D-8
3 - SET-UP MODE
SELECT REPORT
documentation for