Removing The Microsd Card - Motorola MC9500-K User Manual

Unhook the handstrap.
3.
Press the two battery release latches to release the battery. The battery ejects slightly.
4.
Removing the Battery
Figure 1-3
Lift the battery from the MC9500-K.
5.
Insert the replacement battery, top first, into the battery compartment in the back of the MC9500-K.
6.
Press the battery down until the battery release latches snap into place.
7.
The MC9500-K powers up after inserting the battery.

Removing the microSD Card

To remove an microSD card:
Suspend the MC9500-K prior to removing the battery. Failure to properly remove the battery may cause
CAUTION
the MC9500-K to cold boot and potential loss of data.
Press the red Power button to suspend the MC9500-K.
1.
Wait two seconds.
2.
Unhook the handstrap.
3.
Remove the battery.
4.
Remove the SD card cover using a flathead screwdriver.
5.
Slide the SD card holder door to the left to unlock.
6.
Lift the microSD card holder door.
7.
Remove microSD card from holder.
8.
Close the microSD card holder door.
9.
Slide the microSD card holder door to the right to lock into place.
10.
Align the SD card cover over the access hole and press down until it snaps into place.
11.
Replace the battery.
12.
Battery Latch
Getting Started 1 - 7