Installing The Battery - Motorola MC9500-K User Manual

1 - 4 MC95XX Series Mobile Computer User Guide
Remove SIM card cover using flathead screwdriver.
1.
Slide the SIM card holder door to the left to unlock.
2.
Lift the SIM card holder door.
3.
Insert the SIM card, as shown in
4.
notch facing up.
Close SIM card holder door and slide to the right to lock into place.
5.
Align the SIM card cover over the access hole and press down until it snaps into place.
6.
Install the battery.
7.
After completing initial MC9596 setup or after replacing a SIM card:
8.
Press the red Power button.
a.
On the Today screen, tap Wireless Manager.
b.
Ensure Phone is on.
c.
Press the red Power button to suspend the MC9596.
d.
Perform a warm boot. See Resetting the MC9500-K on page 3-3.
e.
Make a call to verify cellular connection.
f.
NOTE For detailed information about WWAN activation and settings, refer to the MC9500-K Series Mobile Computer
Integrator Guide.

Installing the Battery

To install the battery:
Insert the battery, top first, into the battery compartment.
1.
Press the battery down into the battery compartment until the battery release latches snap into place.
2.
Battery
Inserting the Battery
Figure 1-2
The MC9500-K powers up automatically after inserting the battery, if the battery has been charged previously.
3.
into the holder door with the contacts facing down and the card
Figure 1-7
Battery Release Latch
Battery Release Latch