Additional functions
You can use this menu to customize the current program to suit
technical requirements and the wash load or to reset all additional
functions to the factory default settings.
Additional specialist knowledge is required to alter program settings
and this should therefore be undertaken only by experienced users or
by Miele Service.
Changing program parameters on a validated machine will
necessitate a renewed performance validation.
Open the
Additional settings
the button and then switch it on again with the button whilst
keeping the button pressed in.
Open the menu as follows:
Additional settings
Additional functions
–
Reset
All parameters that have been set under "Additional functions" will
be reset to the factory default setting.
Increased water level
–
The water level will be increased for all programs.
Rinse
–
All programs that incorporate this option will have an extra interim
rinse stage (see the program chart).
Dispensing system
–
Venting the dispensing system and renaming it.
Temperature / Time
–
Adjust the temperature and holding time for the Main wash or Final
rinse program block.
Use the and arrow buttons to select an option and confirm
your selection with OK.
See the next section for details of how to continue.
menu by switching the machine off with
Additional functions
Reset
Increased water level
Additional settings
79