Electrical Connection; Equipotential Bonding Connection - Miele PG 8504 Operating Instructions Manual

 All electrical work must be carried out by a suitably qualified
electrician in accordance with local and national safety regulations.
– The electrical installation must be in compliance with current local
and national safety regulations.
– The plug connection must comply with national regulations, the
socket must be accessible after the machine has been installed.
This is to facilitate access for safety checks, for example when the
machine is being commissioned or serviced.
– For hard-wired machines, connection should be made via a suitable
mains switch with all-pole isolation. The contact opening between
all open contacts must be at least 3 mm wide and the mains switch
must be lockable in the open position.
– An equalization of the potentials should be carried out.
– For technical data, see the data plate or the attached wiring
diagram!
– For increased safety, it is recommended to protect the machine
with a 30 mA residual current device (RDC).
– If replacing the power cord, use only original Miele replacement
parts or a suitable cord with core cable ends.
Further notes on electrical connection are given on the Installation
diagram supplied with the machine.
The machine must only be operated with the voltage, frequency and
fusing shown on the data plate.
This appliance can be converted to a different type of power
supply in accordance with the conversion diagram and wiring
diagram supplied.
A data plate can be found on the inside of the door and another on
the back of the machine.
The wiring diagram is supplied with the machine.
WARNING
THIS APPLIANCE MUST BE GROUNDED

Equipotential bonding connection

There is a screw connection point marked  at the back of the
machine, to which additional equipotential bonding can be
connected.

Electrical connection

121