Piranha4 RGB + NIR / Mono Camera User's Manual
Appendix E: Camera, Frame
Grabber Communication
Setting Up Communication between the Camera and the Frame
Grabber
Teledyne DA LSA Camera Link cameras support the GenCP Camera Link standards.
To configure Teledyne DA LSA GenCP Camera Link Cameras:
1. Install the Teledyne DA LSA frame grabber in the host computer; refer to the hardw are
installation manual.
2. Install Sapera LT and the Teledyne DA LSA frame grabber driver.
3. Connect the camera to the frame grabber; refer to the camera installation manual.
4. Pow er up the camera and w ait until the status LED is solid green.
5. Run the Sapera Configuration utility and select the frame grabber serial port connected to the
camera. Set Teledyne D ALSA camera detection to Automatic D etection and Baudrate to Auto
D etect & M aximize.
6. If the camera w ill be configured using three-letter text commands via a terminal program, such
as H yperTerminal, then set COM port mapping (optional) to an available COM port (e.g.
COM 2).
Teledyne DALSA
109
03-032-20217-01