Ordering - GE D30 series Instruction Manual

2.1 INTRODUCTION
2
Table 2–2: OTHER DEVICE FUNCTIONS
FUNCTION
Breaker arcing current (I
Breaker control
Broken conductor detection
Contact inputs (up to 96)
Contact outputs (up to 64)
Control pushbuttons
CyberSentry™ security
Digital counters (8)
Digital elements (48)
Direct inputs and outputs (32)
Disconnect switches (8)
DNP 3.0 or IEC 60870-5-104 protocol
Event recorder
a) OVERVIEW
The D30 is available as a 19-inch rack horizontal mount or reduced-size (¾) vertical unit and consists of the following mod-
ules: power supply, CPU, CT/VT, digital input and output, transducer input and output, and inter-relay communications.
Each of these modules can be supplied in a number of configurations specified at the time of ordering. The information
required to completely specify the relay is provided in the following tables (see chapter 3 for full details of relay modules).
Order codes are subject to change without notice. See the GE Multilin ordering page at
http://www.gedigitalenergy.com/multilin/order.htm
NOTE
The order code structure is dependent on the mounting option (horizontal or vertical) and the type of CT/VT modules (regu-
lar CT/VT modules or the HardFiber
2-2
Figure 2–1: SINGLE LINE DIAGRAM
FUNCTION
2
t) Fault detector and fault report
Fault locator
FlexElements™ (8)
FlexLogic equations
IEC 61850 communications (optional)
Line pickup
Metering: current, voltage, power, power
Modbus communications
Modbus user map
Non-volatile latches
Non-volatile selector switch
Oscillography
Setting groups (6)
TM
modules). The order code options are described in the following sub-sections.
D30 Line Distance Protection System
factor, frequency
for the latest ordering options.
2 PRODUCT DESCRIPTION
FUNCTION
Time synchronization over IRIG-B or
IEEE 1588
Time synchronization over SNTP
Transducer inputs and outputs
Trip bus
User-definable displays
User-programmable LEDs
User-programmable pushbuttons
User-programmable self-tests
Virtual inputs (64)
Virtual outputs (96)
VT fuse failure

2.1.2 ORDERING

GE Multilin