Iec 61850 Goose Integers; Teleprotection Channel Tests - GE D30 series Instruction Manual
Line distance protection
system.
ur series
Hide thumbs
Also See for D30 series:
- Instruction manual (686 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (620 pages)
Table of Contents
Advertisement
6 ACTUAL VALUES
These actual values represent the state of direct devices 1 through 16.
PATH: ACTUAL VALUES
STATUS
IEC 61850
GOOSE UINTEGERS
MESSAGE
MESSAGE
The D30 Line Distance Protection System is provided with optional IEC 61850 communications capability.
This feature is specified as a software option at the time of ordering. Refer to the Ordering section of chap-
ter 2 for additional details.
The IEC 61850 GGIO5 integer input data points are displayed in this menu. The GGIO5 integer data values are received
via IEC 61850 GOOSE messages sent from other devices.
PATH: ACTUAL VALUES
STATUS
TELEPROT CH TESTS
MESSAGE
MESSAGE
MESSAGE
MESSAGE
The status information for two channels is shown here.
•
CHANNEL 1 STATUS: This represents the receiver status of each channel. If the value is "OK", teleprotection is
enabled and data is being received from the remote terminal; If the value is "FAIL", teleprotection enabled and data is
not being received from the remote terminal. If "n/a", teleprotection is disabled.
•
CHANNEL 1 LOST PACKETS: Data is transmitted to the remote terminals in data packets at a rate of two packets per
cycle. The number of lost packets represents data packets lost in transmission; this count can be reset to 0 through the
COMMANDS
CLEAR RECORDS
•
VALIDITY OF CHANNEL CONFIGURATION: This value displays the current state of the communications channel
identification check, and hence validity. If a remote relay ID does not match the programmed ID at the local relay, the
"FAIL" message will be displayed. The "N/A" value appears if the local relay ID is set to a default value of "0", the chan-
nel is failed, or if the teleprotection inputs/outputs are not enabled.
GE Multilin
IEC 61850 GOOSE UINTEGERS
UINT INPUT
1
0
UINT INPUT
2
0
UINT INPUT 16
0
TELEPROT CH TESTS
CHANNEL 1
STATUS: n/a
CHANNEL 1 LOST
PACKETS:
1
CHANNEL 2
STATUS: n/a
CHANNEL 2 LOST
PACKETS:
1
VALIDITY OF CHANNEL
CONFIGURATION: FAIL
menu.
D30 Line Distance Protection System
6.2.17 IEC 61850 GOOSE INTEGERS
6.2.18 TELEPROTECTION CHANNEL TESTS
Range: n/a, FAIL, OK
Range: 1 to 65535 in steps of 1
Range: n/a, FAIL, OK
Range: 1 to 65535 in steps of 1
Range: n/a, FAIL, OK
6.2 STATUS
6
6-9
Advertisement
Table of Contents
