GE D30 series Instruction Manual page 17
Line distance protection
system.
ur series
Hide thumbs
Also See for D30 series:
- Instruction manual (686 pages) ,
- Communications manual (532 pages) ,
- Communications manual (526 pages)
Table of Contents
Advertisement
1 GETTING STARTED
•
To configure the D30 for remote access via the rear Ethernet port, see the Configuring Ethernet Communications sec-
tion. An Ethernet module must be specified at the time of ordering.
•
To configure the D30 for local access with a laptop through either the front RS232 port or rear Ethernet port, see the
Using the Quick Connect Feature section.
b) CONFIGURING SERIAL COMMUNICATIONS
Before starting, verify that the serial cable is properly connected to the RS485 terminal on the back of the device. The face-
plate RS232 port is intended for local use and is not described in this section; see the Using the Quick Connect Feature
section.
A GE Multilin F485 converter (or compatible RS232-to-RS485 converter) is required. Refer to the F485 instruction manual
for details.
1.
Verify that the latest version of the EnerVista UR Setup software is installed (available from the GE EnerVista CD or
online from http://www.gedigitalenergy.com/multilin). See the Software Installation section if not already installed.
2.
Select the "UR" device from the EnerVista Launchpad to start EnerVista UR Setup.
3.
Click the Device Setup button to open the Device Setup window and click the Add Site button to define a new site.
4.
Enter a site name in the "Site Name" field. Optionally add a short description of the site along with the display order of
devices defined for the site. In this example, we use "Location 1" as the site name. Click the OK button when complete.
The new site appears in the upper-left list in the EnerVista UR Setup window.
5.
Click the Device Setup button, then select the new site to re-open the Device Setup window.
6.
Click the Add Device button to define the new device.
7.
Enter a name in the "Device Name" field and a description (optional) of the site.
8.
Select "Serial" from the Interface drop-down list. This displays a number of interface parameters that must be entered
for serial communications.
9.
Enter the relay slave address, COM port, baud rate, and parity settings from the
MUNICATIONS
SERIAL PORTS
GE Multilin
Figure 1–4: CONFIGURING SERIAL COMMUNICATIONS
menu in their respective fields.
D30 Line Distance Protection System
1.3 ENERVISTA UR SETUP SOFTWARE
SETTINGS
PRODUCT SETUP
1
COM-
1-7
Advertisement
Table of Contents
