Note
Note
Run Test Sequence
Overview
Steps
78
If the USB drive is not recognized, check to see
that the function settings for F-20 = 1 (page 90). If
not, reinsert the USB flash drive.
3. Configure T-02 (Test sequnce
Load) to 1~10 (save memory slot)
T-02 range 1~10 (t001 ~t010)
4. The test sequence will now be available in the
memory slot the test sequence was saved to.
Error messages: If you load a file that is not
present on the USB drive "Err 002" will be
displayed on the display.
A test sequence can be run from one of ten
memory slots.
1. Before a test sequence can be run, it
must first be loaded into one of the
10 memory slots.
2. Configure T-01 (Run Test
sequence) to 1~10 (save memory
slot)
T-01 range 1~10
3. The test sequence will automatically start to
run.
2260B Series User Manual
Page 76
Page 77
Page 76